REG. PRICE: $89.95 NEW Lower Price
$79.00
(Std Priority Mail)
$85.00
(Priority Mail & Insurance)
-OR-
Pre-Wired
Harness - $139
(Plug and play)
(You do NOT need both. one or the other)
* The
1999-2002 Cobras have a single
amber turn signal on each side of the car.
As such, you can't install sequential
turn signals on these cars.
However, the 2003+ Cobras have
the standard red lenses. Therefore,
you can install this kit to convert
them to sequential operation.
* NOTE
* USA SHIPPING ONLY.
STS1M - Sequence
Turn Signals '99-04 Get that Retro Look!
The
STS-1M Kit has been specifically designed to work
with any 1996 through 2004 Mustang V6, GT
(except '99-'02
Cobra see sidebar).
Plus, special pigtail connectors are included to
convert the inner lamp sockets to dual filament
functionality. This greatly simplifies the
installation procedure (complete installation only
requires cutting one wire per side) and allows you
to keep your original Ford Factory sockets.
The kit contains everything you need -- there is
nothing else to buy! A bit of mechanical knowledge
is necessary and removal of the taillights too.
(Kit does BOTH
Sides, contains 2 modules)
NOTE: USA SHIPPING ONLY. WE CANNOT SHIP TO CANADA
OR OVERSEAS.
** NEW
2005/06/07 ** Mustang
Sequential Turn Signals
The STS-1M5HR 'Harnesses'
have been specifically designed to work with the New
2005/06 Mustang. These sequential harnesses are completely
assembled and tested and will replace the OEM harnesses
in your car. Simply pull the trunk panels and tail
light housings, unplug the old harnesses and plug in the
new harnesses to have sequential turn signals without
cutting any wires!
#STS-1M5HR